Orlandoo Hunter Or 1/32 Diecast Car Stackable Stand 3D Printer Model
The file 'Orlandoo Hunter Or 1/32 Diecast Car Stackable Stand 3D Printer Model' is (stl) file type, size is 338.0KB.
The file 'Orlandoo Hunter Or 1/32 Diecast Car Stackable Stand 3D Printer Model' is (stl) file type, size is 338.0KB.
I was running out of room on my Orlandoo shelf and this was my solution.
The parts glue together and the units can be stacked.
Enjoy. I hope someone gets some use from it :)
Main Rack, (self supporting car rack)
Glue the Car_stand_Top_latest to the top of "Car_stand_base Latest
Extension part. (Rack extension, not self supporting)
Car_stand_extension, Sits between two "main rack" assemblies
Car stand end. (rack extension with one side supported, use mirror tool to orientate to desired orientation
Glue the 2 beam mounts to the top, then glue to the base.
*note, Does not require supports
*note, at 15% infill its very dependant on the rear supports so it doesn't warp, I recommend printing at a higher infill percentage and allow it to fully cool before removing it from the head bed
| carstand.stl | 201.3KB | |
| carstand_1.stl | 871.7KB | |
| Carstand_end_bottom.stl | 41.3KB | |
| Car_Stand_Base_latest.stl | 106.8KB | |
| Car_Stand_End_top_1.stl | 36.4KB | |
| Car_Stand_Extension.stl | 3.8KB | |
| Car_Stand_Support_latest.stl | 1.1KB | |
| Car_Stand_top_latest.stl | 85.7KB | |
| Complete_Car_Stand.stl | 886.1KB | |
| Complete_Car_Stand_and_Extension.stl | 901.4KB |
