Organizer / Insert For GMT Skies Above The Reich 3D Printer Model
The file 'Organizer / Insert For GMT Skies Above The Reich 3D Printer Model' is (stl) file type, size is 156.0KB.
The file 'Organizer / Insert For GMT Skies Above The Reich 3D Printer Model' is (stl) file type, size is 156.0KB.
An organizer/insert for GMT's Skies Above the Reich by Jerry White and Mark Aasted.
Note 1 - I have the 2nd printing - I don't think box size, block size, or mapboards changed from 1st printing but it is possible.
Note 2 - You can use this insert for Storm Above the Reich if you sourced your own smaller blocks to match Skies.
Note 3 - to save filament and not make the counter wells too deep, I have placed 6mm of foam riser under everything but the card box.
Supports sleeved cards and vertical storage. No lid lift.
Print quantities:
1x AboveTheReich-CardBox.stl (Nose, Oblique, Tail)
1x AboveTheReich-CardInsert.stl (Continuing Fire)
1x AboveTheReich-Spacer_Upper.stl (holds boards and rules in place, also holds bags)
1x SkiesAboveTheReich-CounterBoxSmall.stl (holds the smaller counters but is large in size!)
1x SkiesAboveTheReich-CounterBoxLarge.stl (holds the large 1" counters but is small in size!)
1x SkiesAboveTheReich-Spacer_Lower.stl (fills a gap to hold everything tight)
2x SkiesAboveTheReich-Team.stl (one each for red and yellow teams)
You can see in the pictures that I put 2 drawstring bags into the Upper Spacer compartments to draw damage and hit markers from.
| AboveTheReich-CardBox.stl | 106.2KB | |
| AboveTheReich-CardInsert.stl | 59.5KB | |
| AboveTheReich-Spacer_Upper.stl | 59.8KB | |
| SkiesAboveTheReich-CounterBoxLarge.stl | 127.8KB | |
| SkiesAboveTheReich-CounterBoxSmall.stl | 165.6KB | |
| SkiesAboveTheReich-Spacer_Lower.stl | 53.0KB | |
| SkiesAboveTheReich-Team.stl | 173.7KB |
