Remix from this fine job:
https://www.myminifactory.com/object/3d-print-nirumbee-wand-stand-or-wacom-pen-stand-2877
Hollow inside with very thin sphere walls (only two layers thick)
need supports, ive made supports only from the bed through all thing to support top side of the orb from inside.
Im adding stand to put it on the table
After printing inserted some RGB lcd with digispark controller to control color
| Orb_100mm_in_Dragon_claw.obj | 36.8MB | |
| Orb_Claw_Stand.STL | 4.4MB | |
| Orb_in_Dragon_claw.obj | 36.8MB | |
| Orb_in_dragon_claw.stl | 113.4MB | |
| Without_Orb_100mm_in_claw.obj | 14.6MB | |
| Without_Orb_in_claw.obj | 15.6MB |
