Orange Pi Lite Slim Case Pro (Antenna Front) 3D Printer Model
The file 'Orange Pi Lite Slim Case Pro (Antenna Front) 3D Printer Model' is (STL) file type, size is 1.4MB.
The file 'Orange Pi Lite Slim Case Pro (Antenna Front) 3D Printer Model' is (STL) file type, size is 1.4MB.
This version has the WiFi antenna on the Front. See the Back version here:
https://www.thingiverse.com/thing:2772794
See the Standard version of this case here (Standard Wifi antenna):
https://www.thingiverse.com/thing:2778278
This is a compact and slim case for the Orange Pi Lite.
It has a swivel WiFi antenna that folds to the front whenever needed for storage and transportation.
It'll even fit inside the box that the OPi Lite came in!
In this Front version, you loose access to the push button, but with Back version it's there.
It's a passively cooled case with access to GPIO pins by removing the plastic protection.
It's build for low/med performance, running constantly at 100% load may not be a good idea due to being passively cooled. Should not be worse than running the card naked though.
For use with OctoPrint, CPU temp average at ~40°-50°C.
[Mechanical parts needed]
4 pcs M3x12 insex screws
4 pcs M3 nuts
[Electronic parts needed]
Orange Pi Lite
Orange Pi Heatsinks
RP-SMA Antenna Adapter
2.4Ghz Antenna
[DONATIONS]
If you find that the item improve your daily life, consider supporting the designer by sending a tip.
Click "TIP DESIGNER" here.
| OPi_Lite_Case_3_Bottom_1-1.STL | 2.2MB | |
| OPi_Lite_Case_3_Top_1-1.STL | 1.9MB |
