Since I often access my electronics by lifting up the heated bed and always had to leave it hanging on the cords somewhere, I designed these to hold the print bed when tinkering.
The gap fits a 4-5mm thick bed and the hooks are attached with 2 M3 screws and nuts.
Please note that you need some kind of base that is at least 51 mm high to mount them on the inside of the printer (otherwise you won't be able to but your bed back in horizontal position). If not, you can mount them on the outside of your printer.
I mounted them below an Openbeam easily since the original Kossel corner pieces have openings to drop nuts (or lift, in this case) in the beams while the thing is fully assembled.
If you can't do it that easily, there are probably other holder designs out there which suit your printer better.
| HeatedBedHolder.stl | 138.6KB | |
| HeatedBedHolder_twice.stl | 277.0KB |
