OpenBCI Cover For V3 + Daisy Board (fits The Original Board Holder) 3D Printer Model
The file 'OpenBCI Cover For V3 + Daisy Board (fits The Original Board Holder) 3D Printer Model' is (SLDPRT,STL) file type, size is 204.7KB.
The file 'OpenBCI Cover For V3 + Daisy Board (fits The Original Board Holder) 3D Printer Model' is (SLDPRT,STL) file type, size is 204.7KB.
This is a cover for the OpenBCI V3 32bit and Daisy board (16 channel open source EEG/EMG/ECG). It covers both boards while they're stacked on top of each other, which the original covers don't.
It simply snaps onto the BOARD_HOLDER.stl that is found in the Ultracortex III repository.
https://github.com/OpenBCI/Ultracortex/blob/master/Mark_III_Nova/STLs/HOLDER_AND_COVER/BOARD_HOLDER.stl
The cutouts for the headers on the 32bit don't line up perfectly, but it's good enough to run wires through them. There's quite some room left inside the enclosure to place some electronics or a small LiPo.
If the fit is too loose, heat up the tabs of the BOARD_HOLDER a little with hot air and bend them to the outside for a mm or so. That way this parts stays on more securely.
| OpenBCI+daisyCAP.SLDPRT | 458.5KB | |
| OpenBCI+daisyCAP.STL | 46.7KB |
