This is open differential for Jeep Rancher from 3dsets. I test it on version Wagon, but should be possible to mount it also on other versions.
I created it this open diferencial, because I'm using my Rancher in house on vinyl floor and the adhesion is so good - and it overloads cardan joints.
The idea was to use maximum of original parts. For two pieces of differential you need only:
6x bearings 10X15X4 6700 2RS (same like is used everywhere in Rancher)
10x screw M3x12
and 3d printed parts
Print settings for case/box 0.2mm-20%, all other parts 0,15mm-100% infill
I printed on Prusa Mini
Assembly manual should be clear from photos.
Don't forget put in grease.
NOTE: Maybe it will be necessary to shorter Drive Shaft - Differential side, because new differential is little bit longer. On my Wagon version I did only for front axle.
| Carrier_planet_bottom.stl | 6.1MB | |
| Carrier_planet_top.stl | 154.4KB | |
| DiffBoxBottom.stl | 794.8KB | |
| DiffBoxTop.stl | 799.5KB | |
| GearPlanet_1005mm.stl | 1.1MB | |
| GearPlanet_1015mm.stl | 1.1MB | |
| GearWheel_Front_Axis.stl | 1.3MB | |
| GearWheel_Rear_Axis.stl | 1.3MB | |
| Shaft_Axle.stl | 155.0KB | |
| Sun.stl | 2.9MB |
