This is a Quadcopter Racing Frame measuring about 27cm diagonally. I tried to make it a 250 frame, but I had problems with the props - so I scaled it up a bit. It is quite light - about 370g alltogether without the battery attached. I have chosen this design because I like to work with triangles and it prints well. The objects are modelled optimized for 3d print without the use of support material which I don't really like.
The Onyx was designed to bear a fatshark fpv camera at the front with an adjustable pitch angle. The roof can be lift and fixed in open position to tweak controller settings. The layout is optimized for a RC setup with Afro V3 12A ESCs, Multistar 1704 Motors and a KK Mini Controller I bought as a kit. But I think the measurements are pretty standard.
The focus was not speed but design. I know there are some flaws, but it was my first quadcopter project. It flies - good too!
| RF_arm_BL.stl | 24.4KB | |
| RF_arm_BR.stl | 24.4KB | |
| RF_arm_FL.stl | 23.3KB | |
| RF_arm_FR.stl | 23.3KB | |
| RF_body.stl | 92.8KB | |
| RF_camera_clip.stl | 12.0KB | |
| RF_complete.stl | 333.3KB | |
| RF_roof.stl | 8.6KB |
