For those of you who want the LED light bar and switch https://www.thingiverse.com/thing:3292889
but don't need the whole front SD card converter and housing https://www.thingiverse.com/thing:3292867, here is my simple box for holding the switch and electrical connectors.
You can screw to your aluminum extrusions with m4 screws and T nuts.
There is a rear cap to close off the back if needed.
I recommend bolting on to your frame first, passing the cabling in through the rear and out the front hole, wiring the to the switch, then snap the switch into place
for use with simple round Rocker Switch: (affiliate link) https://amzn.to/2CzkYQG
M4 T-nuts (affiliate links) : https://amzn.to/2PgbkFZ
and M4 button cap screws - need about 8 mm long (affiliate links): https://amzn.to/2rgrwNK
use the slip on crimp connectors(affiliate links): https://amzn.to/2QWEi3u
print face down, no supports!
see assembly here: https://youtu.be/EbfK2CAmvHg
December 28, 2018: updated files to have a bit more lip on back cover
If you make it please post your photos!
| switchbodypsd2.STL | 2.3MB | |
| switchcoverpsd2.STL | 306.9KB |
