After about two years of thinking about printing an actual phonecase for my trusty OnePlus X, I finally took the time to model one. The fit is really thight and i'd suggest scaling the model up a bit if you're printing in ABS, which you should probably do. Support may be helpfull but isn't stricly necessery if your printer handles bridging well.
EDIT: Turns out I am not able to use a caliper... the icon cutout did not line up with the actual icon. I fixed this in V2. Also, i found out that you can increase the cases snugg-i-ness by heating up the corner pieces with a lighter for a second and bending them inwards over the phone. You wont be able to get your phone out without breaking the case, but hell- just print another one... they are like 30 cents in material...
| oneplusx.stl | 451.4KB | |
| V2.stl | 451.4KB |
