I'm posting this as a remix, however I did design this from the ground up. I initially tried JimmyJohansson's design and it seemed the holes for the charger ends were a bit too small and the stand was incompatible with my pop socket. So I decided to learn Fusion 360 and design one from scratch with obvious inspiration from Jimmy.
So this is clearly a charging dock for the Oneplus 6 smartphone. It is designed for use with the included clear TPU case. I've made the tolerances a little larger to make cable installation a little easier with a little less filing of the holes. The holes should be .5 mm wider than the cable itself where the cable seats in its final destination. Holes for initial threading of cable are quite large for quick removal and installation of cable. A nice little cable catch and route runs out the back of the stand for tidiness.
There is a sound redirection channel designed into this under the speaker. While it doesn't particularly "improve" the sound, it certainly avoids the muting of the speaker that would occur without the hole there. I tried to create some interesting acoustic properties by way of enlarging the channel and then widening it to give it better apparent "stereo" and bass, but I failed. It sounds fine, but it's no Bose.
The back has a goofy but functional form to address the issue of Pop sockets and their popularity. I personally find them stupid looking but functional and wanted to make sure this wouldn't interfere with my sweet pokeball Pop socket. I gave some liberal tolerance to the back form to make sure it would work with a decent amount of Pop socket installations. The containing arms of this are a little wider to allow for any tiny bits of play the charger might experience, however I made them a bit taller to accommodate for this design choice.
Finally, I made a nice little badge for the front of it so you don't forget what brand your phone is. I feel like it's a nice balanced badge, mostly debossed for clarity with a small embossed accent around the word that screams luxury ;)

This is my first attempt at Fusion 360. If you have feedback, please leave it. If there is an error in design, I'd love to try and fix it. Have a great day, and thanks to JimmyJohansson for the inspiration.