Onefinity Makita 65mm 2.25in Dust Boot 3D Printer Model
The file 'Onefinity Makita 65mm 2.25in Dust Boot 3D Printer Model' is (stl) file type, size is 411.6KB.
The file 'Onefinity Makita 65mm 2.25in Dust Boot 3D Printer Model' is (stl) file type, size is 411.6KB.
Save a bunch over the the PwnCNC and SuckIt dust boot options. This Dust shoe clamps directly on to the router with a hose clamp, follows the z-axis, and has a removable magnetic base for easily switching bits. This is a unique design but was inspired by both https://www.thingiverse.com/thing:4798675 and https://www.thingiverse.com/thing:6188585. Check out their options for 4in dust collection ports!
This design is specifically meant for Rigid standard 2.25in couplings.
This design has been updated to add shear pins between the top and bottom of the dust shoe, and to add a magnetic hose attachment with shear pins as well. The side/lateral loading of the shoe previously caused it detach in some cases. The shear pins prevent this while magnets are holding the mating surfaces together. Add an M3 x 25mm socket cap screw and nut to each pin location.
This design uses 12mm x 3mm rare earth magnets (Amazon search if link is bad). I used these: https://www.amazon.com/dp/B0CCVPVQ1L?psc=1&ref=ppx_yo2ov_dt_b_product_details
This design also uses a 100mm x 1mm dust shoe brush strip (Amazon search if link is bad). I used this one: https://www.amazon.com/dp/B07VNSD1CJ?psc=1&ref=ppx_yo2ov_dt_b_product_details
| Hose_Adapter.stl | 2.1MB | |
| Makita_Dust_Boot_Bottom.stl | 1.2MB | |
| Makita_Dust_Boot_Top.stl | 2.7MB |
