This cube took a little while to design. I worked pretty hard on the latch to try to get it to work well and succeeded so try not to change the dimensions. Don't do too high of a support material infill percentage as it will make it hard to remove. I would recommend about 40-50% support infill at a 45 degree angle. This will make it easy to remove but will allow the highest detail and the most function in the hinge. Hope you enjoy! :)
Link to Puzzle Cube: https://www.thingiverse.com/thing:3205710
| Puzzle_Cube_Box_Full.stl | 1.0MB |
