Inspired by the original design from DoctorLaser, I made this variant that uses a separate wall mount. That way, you can screw it into the wall without the screws being visible.
Everything else is press fit. The cable also is positioned differently compared to the original and is now completely flush with the side of the holder.
The left and right versions are mainly to accommodate the cable when rotating towards the play area. So for a regular setup with two sensors, you would print two wall mounts and one of each holder.
I recommend printing it on its side as shown in the picture using supports.
| Holder_Left.stl | 34.0KB | |
| Holder_Right.stl | 34.0KB | |
| Wall_Mount.stl | 32.7KB |
