This is a wall mount for the Oculus Quest and it's two controlers. It makes it easy to store and use the quest with out needing a case.
I printed it in PLA. Any material will work. Just print it with a few walls and decent infill. It doesn't need to be supper strong.
The End Cap screws or glues onto the end of the wall mount. It's needed to stop the headset from sliding off. If you use screws I used #6 3/4 in screws.
All the holes for wall mounting are also designed to use #6 3/4 in screws. Drywall anchors are not mandatory. I did not use them, after all the headset is fairly light.
| Quest_Controler_Holder_V1.1.stl | 239.3KB | |
| Quest_Wall_Mount_End_Cap_V1.0.stl | 334.2KB | |
| Quest_Wall_Mount_V1.0.stl | 2.1MB |
