OctoPrint Control Box 3D Printer Model
The file 'OctoPrint Control Box 3D Printer Model' is (STL,pdf) file type, size is 1.5MB.
The file 'OctoPrint Control Box 3D Printer Model' is (STL,pdf) file type, size is 1.5MB.
This box contains a Raspberry Pi running the fabulous OctoPrint / OctoPi, a 5 V power supply and an SSR. It allows you to remotely turn on and off your attached 3D printer, either by using the web interface, by sending G-Code or with a custom system command, which is needed to use the feature through the Telegram plugin.
The two hardware buttons are used to power on/off the printer or send a shutdown command to properly power off the Pi.
Next to the hardware setup you will need to install three additional plugins:
All are available in the Octoprint Repository.
SAFETY WARNING:
This build works with mains voltage which is dangerous and potentially lethal. Only attempt this build if you know what you are doing. I am no electrician, it's all at your own risk!
HINT:
The thumbnail for the PDF schematic somehow does not work with "Show Original". I therefore included a PNG version for quick viewing. Of course you can always download the PDF from the files section for best quality.
| 40mm_fan_shroud.STL | 5.1MB | |
| Controller_Box_Case_-_Bottom_-_M3-M2.5.STL | 4.7MB | |
| Controller_Box_Case_-_Bottom_-_M3_only.STL | 4.7MB | |
| Controller_Box_Case_-_Top.STL | 8.5MB | |
| OctoPrint_Control_Box_Schematic_v1.pdf | 63.1KB | |
| Spacer_5mm.STL | 265.1KB |
