This was tested on an R.B. Cycle Graphic No. 6 Cirkut Outfit. you will need an 8/32 x 1-inch bolt for this to work. The hole is undersized for the thread to grab on.
A note: Today I noticed my base plate has some foam and felt glued on it making it much taller than a normal No.6 Cirkut Outfit. If you want to help me, comment below the distance from the bottom of the Cirkut back gear drive hole to the top of the gear on the base. This will give me all I need to make the correct gears for everyone else. If you have a different Cirkut such as a No.8 or No.10, message me and maybe I can make some gears on a different post.
As of 08.09.2024, I fixed the above. I am still working to add a full list of gear for infinity.
I'll link a spreadsheet I worked on for Jim Galli on the site Photrio.
08.09.2024: Added
44t, 48t, 49t, 50t, 51t, 62t
08.10.2024: Added
24t, 27t, 28t, 29t 30t, 31t, 32t, 33t
| 24t_Add_Bolt.stl | 364.8KB | |
| 27t_Add_Bolt.stl | 368.3KB | |
| 28t_Add_Bolt.stl | 373.4KB | |
| 29t_Add_Bolt.stl | 369.3KB | |
| 30t_Add_Bolt.stl | 374.6KB | |
| 31t_Add_Bolt.stl | 381.1KB | |
| 32t_Add_Bolt.stl | 386.0KB | |
| 33t_Add_Bolt.stl | 391.5KB | |
| 44t_Add_Bolt.stl | 535.6KB | |
| 48t_Add_Bolt.stl | 559.0KB | |
| 49t_Add_Bolt.stl | 567.2KB | |
| 50t_Add_Bolt.stl | 575.4KB | |
| 51t_Add_Bolt.stl | 558.2KB | |
| 62t_Add_Bolt.stl | 601.2KB |
