Nozzle Probe Guide 3D Printer Model
The file 'Nozzle Probe Guide 3D Printer Model' is (stl) file type, size is 604.2KB.
The file 'Nozzle Probe Guide 3D Printer Model' is (stl) file type, size is 604.2KB.
Did you ever have trouble getting a wire to go into the end of the nozzle? This makes it easy with a funnel on both ends. Top funnel lines up nozzle and bottom funnel makes a big target to guide the tiny wire into the tip of the nozzle.
This would be better if it could be made of metal but I'm lazy.
-NPG_01 has a 1mm dia hole but it tends to shrink a lot when printed. If the 0.4mm probe won't go through you can either drill it out with a #78 drillbit or you can push a heated pin through the blockage.
January 15:
-NPG_02 has a 1.2mm dia hole which may also be too tight but it should be easier to push a pin through.
Jan 28:
-Found a mistake in my drawing and corrected it. Also moved handle to the bottom of the tool so that it could be printed vertically to get a rounder interior. No support needed.
-Uploaded NPG_05
| NPG_01.stl | 490.1KB | |
| NPG_02.stl | 670.4KB | |
| NPG_05.stl | 527.5KB |
