This Nori feeder is easily printed in five parts. The back, front grid, and magnet cover for inside the tank, and the corresponding outside-tank magnet enclosure.
It is designed for the 32mm x 2mm magnets commonly available online.
One half sheet tall (3.9", 10cm) by one strip wide (2.75"/7cm), this feeder can fit 8-10 sheets for your hungry critters.
With one magnet on each side, it will work on glass/acrylic up to 3/8" thick.
For thicker material, use the double magnet cover and two magnets on each side.
Remove the feeder after feedings for the longest life.
Note: Barr Aquatic Systems is the only manufacturer authorized to commercially sell this design.
| Nori-back.stl | 923.0KB | |
| Nori-front.stl | 326.8KB | |
| Nori-Mag-Cap-Dbl.stl | 536.6KB | |
| Nori-Mag-Cap.stl | 252.0KB | |
| Nori-Mag-Holder.stl | 685.9KB |
