I didn't like the two halves of the blade being split and put the two halves together. I also put the two halves of the handle together as in my first make, I could see the threaded rod inside. The first piece of the blade didn't make sense to combine
Print vertically to maintain the hole in the middle. Threads perfectly onto a 5/16" (7.9 mm) threaded rod. I used a wing nut to tighten down the blade sections while the glue was drying.
| Lame_-_lame_2T_dual.stl | 47.1KB | |
| Lame_-_lame_3T_dual.stl | 67.4KB | |
| Lame_-_lame_4T_dual.stl | 29.4KB | |
| Lame_-_lame_5T_dual.stl | 55.6KB | |
| total_-_Poignet_3_dual.stl | 20.8KB |
