Non-Corridor Carriage Seating 3D Printer Model
The file 'Non-Corridor Carriage Seating 3D Printer Model' is (3mf,stl) file type, size is 161.6KB.
The file 'Non-Corridor Carriage Seating 3D Printer Model' is (3mf,stl) file type, size is 161.6KB.
A set of seating units for model railway carriages - designed for 4mm/00 gauge non-corridor carriages with etched bodies, these seating units are intended to be attached to compartment dividers.
They are based on LSWR carriage seating, and measure 29.5mm across. They can also be stretched vertically if needed to suit height requirements.
Three classes of seating are offered:
These are intended for printing on a filament printer, although I see no reason a resin one could not be used. Printing right-side-up with ironing switched on should provide a good-enough finish for inside a carriage.
| First_Lav_Compartment.3mf | 149.6KB | |
| First_Lav_Left.stl | 16.5KB | |
| First_Lav_Right.stl | 16.5KB | |
| First_Seat.stl | 27.5KB | |
| Second_Lav_Left.stl | 20.4KB | |
| Second_Seat.stl | 23.7KB | |
| Third_Lav_Left.stl | 18.5KB | |
| Third_Lav_Right.stl | 15.2KB | |
| Third_Seat.stl | 20.5KB |
![Sydney Urbos 3 [1:87] 3D Printer Model](https://cdn.3axis.co/assets/49/b0/5f/5a/49b05f5a-a15c-4c67-b7d0-2e685edf57e4/images/bbe62102-f4a6-42f3-96f9-182b276245a1_thumb.jpg)
