No-Glue Pylon Crystal 3D Printer Model
The file 'No-Glue Pylon Crystal 3D Printer Model' is (stl) file type, size is 120.5KB.
The file 'No-Glue Pylon Crystal 3D Printer Model' is (stl) file type, size is 120.5KB.
Because I have a very basic printer, I had to use the 4 separate files of the original Protoss Pylon light and there was not enough surface area to easily glue the crystal together.
I decided to try to make a few adjustments to the crystal so it could be assembled without glue and, if needed, could be disassembled to replace an LED inside the crystal.
I also added a small hole in the crystal so that a wired light could be placed inside.
The fit is a little tight, but just wiggle the top crystal part over the bottom after lining them up properly and it will snap together securely.
| No_Glue_Pylon_Bottom_Crystal.stl | 143.4KB | |
| No_Glue_Pylon_Top_Crystal.stl | 127.8KB |
