Credit: Got the Idea from here : http://www.instructables.com/id/Lantern-Clock/?ALLSTEPS
To assemble the Lanterns you'll need:
12 3x100 mm threaded rod (may be a bit to long but rather to long than to short)
3 3x20mm bolt
3 60x50x60 perspex tubes
30 3mm dome nuts
3 3x60mm threaded rod or 3x60mm screw
3 4x75mm threaded rod
3 4x 280mm threaded rod
12 4mm dome nuts
wood for stand - I used normal pine shelving
Electronics to drive the nixie tubes - got mine here: http://www.open-rate.com/Store.html
PCB for nixie tubes - gerber files included.
Print quantities: In the file name. The side plates can be 1 off each though.
I'm still finishing up the clock and will update as I continue ....
Update: clock is done. I did add some feet and a box for the electronics. Enjoy!!
| Bottom_Gear_-_3_off.stl | 1.7MB | |
| bottom_spacer_-_6_of.stl | 717.6KB | |
| box_cover_1_off.stl | 196.4KB | |
| Elect_Box_-_1_off.stl | 2.1MB | |
| feet1_2_off.stl | 665.6KB | |
| feet2_2_off.stl | 669.2KB | |
| hanger_-_3_off.stl | 4.9MB | |
| hanger_bearing_-_3_off.stl | 5.1MB | |
| Holder_-_12_off.stl | 961.8KB | |
| Middle_Gear_bottom_-_3_off.stl | 2.6MB | |
| Middle_Gear_top_-_3_off.stl | 2.7MB | |
| Nixie_tube-B_Cu.gbr | 1.5KB | |
| Nixie_tube-B_SilkS.gbr | 548.0B | |
| Nixie_tube-drl_map.gbr | 19.9KB | |
| Nixie_tube-F_Cu.gbr | 15.7KB | |
| Nixie_tube-F_SilkS.gbr | 21.4KB | |
| PC_Board_Holder_3_Off.stl | 76.0KB | |
| Side_plate_1_-_2off.stl | 1.9MB | |
| Side_plate_2_-_2off.stl | 1.9MB | |
| spacer_-_6_off.stl | 3.0MB | |
| stand_spacers_-_18.stl | 2.6MB | |
| stand_template.pdf | 9.4KB | |
| Tip_-_3_off.stl | 233.1KB |
