Nintendo Switch Stand 3D Printer Model
The file 'Nintendo Switch Stand 3D Printer Model' is (stl) file type, size is 141.8KB.
The file 'Nintendo Switch Stand 3D Printer Model' is (stl) file type, size is 141.8KB.
Got me a Nintendo Switch for Christmas. I like the ability to use the Joy-Con and still play on the small screen, but I found that trying to charge the tablet while propping it up to play was a pain.
I said to myself, "Someone should make a stand that can support this thing either on a flat surface or hanging over a chair or railing, with enough space under it that it's not resting on the charging cable."
So I did.
This is a marathon print; with 3 outer shells per layer and 25% infill for durability of the relatively thin walls, even at 0.2mm layer height, expect this to take 30+ hours. Also be sure your printer and slicer are calibrated for accurate prints; I left a little slack in all dimensions so the Switch slides right back out, but if your printer prints even a little wide it might be a tighter fit than it's supposed to be. However, if you're patient, the results are well worth it.
Nintendo Switch not included.
| Switch_Stand.stl | 2.4MB |
