Nintendo Switch Lite Wall Mount 3D Printer Model
The file 'Nintendo Switch Lite Wall Mount 3D Printer Model' is (STL) file type, size is 7.8KB.
The file 'Nintendo Switch Lite Wall Mount 3D Printer Model' is (STL) file type, size is 7.8KB.
I made this wall mount for the Nintendo switch lite.
The cable has a tight fit to make sure you don't pull out the cable when you remove the switch from the dock. It could be that it needs some sanding when you used supports.
The switch itself has a looser fit, this is done on purpose so you can add a piece of tape on the back and front side so you are sure to not scratch the switch when placing it in the dock and taking it out.
I also adjusted it a little so to have a tabletop version.
It's best to print it on the side (turn 90 degrees) to have to use a little support as possible.
| Table_version.STL | 22.0KB | |
| wall_mount.STL | 12.6KB |
