Nintendo Switch Comfort Grip (by Jgr526) 3 PIECE V3 REMIX 3D Printer Model
The file 'Nintendo Switch Comfort Grip (by Jgr526) 3 PIECE V3 REMIX 3D Printer Model' is (stl) file type, size is 538.9KB.
The file 'Nintendo Switch Comfort Grip (by Jgr526) 3 PIECE V3 REMIX 3D Printer Model' is (stl) file type, size is 538.9KB.
Remix of the V3 grip so it has a independent LEFT, RIGHT, and MIDDLE (flat) piece.
(also a middle split in two, for users with a 120mm or similar small sized bed)
ALSO added a V3.5 (NOT to be mixed parts with V3.) this version added notches in both the middle AND the grips for more contact surface for bonding. These are still expected to be glued or otherwise bonded together!
This was shared with permission from Jgr526 for users who wanted a no-support, easy to print in limited space alternative for printing the grip.
Pictured is WHITE plastic a successful print I made with the files in this remix. (Black being images from the original creator)
.21 layer height, in ABS, .15 thick walls and 18% infill. Using an acetone/abs slurry mix i bonded the middle to the grips, and it holds the switch FIRM, but has ZERO signs it will break at all from this method.
(please note that pictured is the freshly printed and bonded grips, without any post-print sanding really done to them, so it's a little messy looking at the bottom and back)
PLA will work just as well as PETG, but I suggest you use the files with tabs in them for more surface area to epoxy or glue them together then!
Glue the pieces together with a epoxy (or acetone if using ABS)
This can be printed on smaller printers now as well!
| V3.5_Notched_FULL_middle.stl | 7.6KB | |
| V3.5_notched_Left_Grip.stl | 290.8KB | |
| V3.5_notched_Left_Middle.stl | 5.3KB | |
| V3.5_Notched_Right_Grip.stl | 290.8KB | |
| V3.5_notched_Right_Middle.stl | 4.7KB | |
| V3_left_Grip.stl | 292.1KB | |
| V3_middle.stl | 5.3KB | |
| v3_middle_left_half.stl | 3.1KB | |
| v3_middle_left_upright_with_notch.stl | 3.5KB | |
| V3_middle_right_half.stl | 3.1KB | |
| v3_middle_right_upright_with_notch.stl | 3.5KB | |
| V3_Right_Grip.stl | 292.1KB |
