Version 4 can be found here: https://www.thingiverse.com/thing:4822511
A small holder for 8 Nintendo Switch cartridges.
The Nintendo Switch logo was printed separately, and was glued in place with super glue. The darker colour seen in some areas is a result of this.
Note: Some sanding may be required depending on your printer, and settings used.
Changes from V1:
-Added four small notches on the sides of the case,allowing the trays to snap into place to keep them from sliding out.
-Made tabs bigger, allowing the trays to be pulled out more easily
-Added space between the top and bottom tabs
-Added small notches behind the Switch logo, and bumps on the back of the logo itself to aid with keeping it in place
-Removed a small section of the case to make more room for the topmost tab
Link to V1, for those who are interested:
https://www.thingiverse.com/thing:3323787
| Cartridge_Tray_-_Bottom.stl | 319.8KB | |
| Cartridge_Tray_-_Top.stl | 461.8KB | |
| Case.stl | 1.1MB | |
| NS_Logo_1.stl | 58.3KB | |
| NS_Logo_2.stl | 48.1KB | |
| NS_Logo_3.stl | 60.0KB |
