The file 'Nexus 6P Charging Dock 3D Printer Model' is (stl) file type, size is 99.0KB.
Improved 92sho16's file:
1) Connector fits through hole, allowing it to actually connect to phone.
2) Raised height of base so connector could fit in slot without bending cord too much.
As with his model, this is designed to fit the Nexus 6P with a TPU case but a small spacer in the rear could allow for a phone without a case. The hole is sized to fit the charging cords that come with the phone, I'm not sure if any after market ones will work.
My case:
http://www.amazon.com/gp/product/B015P3KNGW?psc=1&redirect=true&ref_=oh_aui_detailpage_o02_s00
But any similar one should work.
To make this semi-permanent I verified correct angle and protrusion of the connector and then squirted a bunch of hot glue in through the bottom. Also added hot glue where the cord comes out so that when the phone is not in the dock it doesn't want to fall over.
Nexus 6P STL
Dock_TPU_V1.stl | 241.7KB |