New Raspberry Pi 4 Honeycomb Case

Designed for Octoprint

If you are looking for a nice Octoprint case, this is right for you.

Also, Raspicam is supported!

No hustle in assembly, just three steps and you are good to go:

1. Print it;
2. Insert the Raspberry Pi;
3. Snap fit all together.

Simple as eating a sandwich.

No fan needed

The case is designed to optimize the air flow and to keep the Raspberry Pi well cooled without the need of a cooling fan.

How it's been made

This is a remix of my Raspberry Pi 4 case. In order to make it much easier to assemble the case with the RPi4, a few changes were made:

• Divided the lower part in two halves for easier inserting of
  Raspberry Pi;
• Added snap fit link between upper case and lower case;
• Added ribaditures to the lower case in order to keep the RPi4
  board in place (using 4 M2.5x8 screws is considered but not
  strictly necessary).
• Minor improvements from the aesthetic point of view.

Variants

As the previous version, the upper case is provided in two variants:

• Upper case cut so as to allow the passage of the RaspiCam's ribbon cable;
• Upper case without the cut.

Hope you enjoy printing my designs as much as I do; if so, like or post a make and, as always, happy printing!