This is a remix of Mr_Meaty's MS Lifecam Studio mount, modified to fit the Trust Trino 18679 Webcam.
It will actually fit some others too, such as my Ausdom 1080P camera and many others using the same rubber mount.
To fit the camera to the mount, remove the 2 screws holding the plastic part of the camera base to the rubber bendy bit, reuse those screws by dropping them down the channels on the printed part.. and screw them back into the plastic base which should fit into the end of the mount as shown in the photos.
Slip it over the X Axis gantry and you are done.
The modified file is on Tinkercad here if you want to remix it further: https://www.tinkercad.com/things/9PJ4iwHsvoC-neptune-4-trust-trino-hd-webcam-18679-mount
| Neptune_4_Trust_Trino_HD_Webcam_18679_Mount.stl | 75.0KB |
