Needle Puller 3D Printer Model
The file 'Needle Puller 3D Printer Model' is (stl) file type, size is 28.1KB.
The file 'Needle Puller 3D Printer Model' is (stl) file type, size is 28.1KB.
This is a simple needle puller, used to effectively remove the needle, or pointer, from gauge's and clock's, without damage.
I have used a Cap Screw Head M5 25mm, for the bolt to push down on the pivot or pointer shaft of the gauge, A fine tip is needed at the end of your bolt, around 1 - 1.4mm should be ok.
If you have a M5 thread tap you can use this to start a thread in the body of your puller.
If you like you can print a fancy handle for the cap, its a very snug fit, just turn a little as you push it together.
| M5_Socket_head_grip.stl | 19.8KB | |
| needle_puller_v1.stl | 82.2KB |
