A SEAL SDV Mk8 in scale 1/16 intended for radio control. Designed with ease of printing in mind, along with a high attention to details. Fully functional hatches.
No support needed except for the propeller, the parts are oriented correctly in the stl files for optimal print direction.
Specs:
Roughly 30 hours of print time and 450g filament.
Prop shaft: 3/16"
Control planes shaft: 2mm.
Total length of the hull is 17" (431mm)
Stand included.
| SDV_mk8_-_1.5in_WTC_craddle.stl | 191.9KB | |
| SDV_mk8_-_2.5in_WTC_craddle.stl | 283.6KB | |
| SDV_mk8_-_2in_WTC_craddle.stl | 283.8KB | |
| SDV_mk8_-_Dive_plane.stl | 4.1MB | |
| SDV_mk8_-_Front_fin.stl | 75.1KB | |
| SDV_mk8_-_Front_wall.stl | 3.0MB | |
| SDV_mk8_-_Hatch_front_left.stl | 493.0KB | |
| SDV_mk8_-_Hatch_front_right.stl | 764.1KB | |
| SDV_mk8_-_Hatch_rear_left.stl | 491.5KB | |
| SDV_mk8_-_Hatch_rear_right.stl | 836.3KB | |
| SDV_mk8_-_Lock.stl | 21.2KB | |
| SDV_mk8_-_Prop.stl | 3.2MB | |
| SDV_mk8_-_Rear_wall.stl | 45.0KB | |
| SDV_mk8_-_Rudder_horn.stl | 79.0KB | |
| SDV_mk8_-_Section_1_-_Bow.stl | 5.1MB | |
| SDV_mk8_-_Section_2_-_Lower.stl | 757.6KB | |
| SDV_mk8_-_Section_2_-_Upper.stl | 563.6KB | |
| SDV_mk8_-_Section_3_-_Lower.stl | 1.2MB | |
| SDV_mk8_-_Section_3_-_Upper.stl | 873.4KB | |
| SDV_mk8_-_Section_4_stern.stl | 3.2MB | |
| SDV_mk8_-_Side_rudder.stl | 3.0MB | |
| SDV_mk8_-_Stand.stl | 991.1KB |
