Tray to keep and organize your National Park Service brochures (unigrids) in.
The trays are modular, i.e. you can have 4 levels by just attaching the same parts together again!
Each level holds about 20 of these maps depending on the thickness.
The larger parts may need to be put diagonally on the bed to fit in one print. Should they still be too large, you can just leave a comment and I'll split them into smaller parts like I did with the back part.
To add the additional 3 trays to the back, you just print the same parts again but leave out the front. The poles for the corresponding level can then be attached to the sides. The height is such that the black line of the brochure peaks right above the row before.
| BackFull.stl | 29.6KB | |
| BackL.stl | 14.1KB | |
| BackR.stl | 22.9KB | |
| Bottom.stl | 25.7KB | |
| Frontflat.stl | 4.6KB | |
| Frontlogo.stl | 530.6KB | |
| Full_Assembly.3mf | 307.3KB | |
| Pole2.stl | 13.7KB | |
| Pole3.stl | 10.8KB | |
| Pole4.stl | 9.2KB | |
| Side.stl | 12.6KB |
