I have always wanted some sort of dedicated charging solution and once I saw Turtle Labs design, I took a serious liking to it, but because theirs is a bit too pricey, I decided to design my own.
This is designed around the Nanuk 910 case, a Meanwell LRS-350 power supply and an ISDT T6 charger.
The plate is just a piece of acrylic I had laser cut and then just added a sheet of carbon fiber vinyl for effect.
I've included my Fusion file for the plate
The XT60 & JDT balance board on the right side is for connecting up your batteries
The XT60 on the left is 24v output straight from the power supply for a second charger
All the hardware is just M3 bolts and M3 plastic nuts. The fan I had to use M4 x 35mm bolts
I plan on weaving a bungee net for the lid side for cable management
Nanuk Case: https://www.amazon.com/dp/B00BP8UWRM/ref=cm_sw_r_cp_apa_i_7igsDbZEQ4XN7
Meanwell Power Supply:
https://www.amazon.com/dp/B013ETVO12?ref=ppx_pop_mob_ap_share
JST Balance Board:
https://www.amazon.com/dp/B07JGFD6Y2/ref=cm_sw_r_cp_apa_i_vhgsDb7WRMMY7
XT60:
https://www.amazon.com/dp/B07GQVHB3V/ref=cm_sw_r_cp_apa_i_qigsDbS65FP3Q
24v Case Fan:
https://www.amazon.com/dp/B00B887J70/ref=cm_sw_r_cp_apa_i_mkgsDbQR8T673
| C14_Plug.stl | 357.0KB | |
| Fan_grate.stl | 615.2KB | |
| ISDT_Brace.stl | 39.3KB | |
| ISDT_trim.stl | 583.4KB | |
| JST_Balance_Board.stl | 454.7KB | |
| Nanuk_Plate.f3d | 2.5MB | |
| Vent.stl | 427.3KB | |
| XT60.stl | 470.2KB |
