NANO ALMA 3D Printer Model
The file 'NANO ALMA 3D Printer Model' is (stl) file type, size is 132.8KB.
The file 'NANO ALMA 3D Printer Model' is (stl) file type, size is 132.8KB.
❓What is?
The Atacama Large Millimeter/submillimeter Array (ALMA) is a radio telescope located in the Atacama Desert in Chile. It is one of the most advanced astronomical observatories in the world, comprised of 66 high-precision antennas that work together to observe the universe at millimeter and submillimeter wavelengths.
🔧Components and Circuit
📎LDR sensors
LDR1: ADC1 (GPIO 32)
LDR2: ADC2 (GPIO 33)
LDR3: ADC3 (GPIO 34)
LDR4: ADC4 (GPIO 35)
📎DHT11 Humidity and Temperature Sensor
VDC: +3.3V GND: GND DATA (OUT): GPIO 2
📎Servo Motors
Servo1 (Vertical): Signal: GPIO 14 VCC: +5V GND: GND
Servo2 (Vertical): Signal: GPIO 15 VCC: +5V GND: GND
Servo3 (Horizontal): Signal: GPIO 16 VCC: +5V GND: GND
📎Yagi antenna Connected to the RTL-SDR dongle, which is connected to the laptop/PC
📎Photovoltaic Cell (5V, 1A) VCC: Connected to the input of the voltage regulator module GND: Connected to GND of the voltage regulator module
📎Voltage Regulator Module Input: Connected to the output of the photovoltaic cell Exit: ESP32 VIN ESP32 GND
📎 Resistors 4 x 10k ohms
📏Software
Software can be found on my github via Link: https://github.com/marcio081010/NANO_ALMA
💲good studies to all💲 ⭐by:Marcio Vinicius
| Acoplamento.stl | 39.0KB | |
| Apoio_estrutural.stl | 10.6KB | |
| Base_para_apoio.stl | 102.4KB | |
| fixação_Antena_Yagi.stl | 43.7KB | |
| Peça_1.stl | 13.9KB | |
| Peça_2.stl | 24.2KB | |
| Sustentação_1.stl | 45.5KB | |
| Sustentação_2.stl | 67.7KB | |
| Sustentação_3.stl | 217.9KB |
