Remix with Tesla Logos and port on the right side.
NOTE: Be aware that on this design the opening on the bottom cable holder mouth area was designed for the smaller diameter Mobile Connector cable so that works perfect there.
If you are using it for the Gen 3 Wall Connector, it's a very tight fit to get the cable in there.
If you have a Gen2 Wall connector, that cable is way too thick and won't go into the slot.
Either way you can always hang the cable for any of your connectors and not use the slot at all like I do. Much easier for everyday use anyway.
| WallConnector.stl | 8.8MB |
