This is my FFF process settings for Simplify3D for PLA.
Printer: Robo3D R1
Hotend: Hexagon, temp = 208C
Bed: Glass + hairspray, temp = 60C. I use other adhesion methods too which require different temps.
Auto-Level: No
Layer Height: 0.3mm (0.2mm is slightly different for the 1st layer's settings to improve bed adhesion)
Note: I set my temps via my RepRapDiscount Full Graphic Smart Controller so I remove all Temperature profiles from my S3D process. The "3DPG" in the file name refers to the filament source, 3DPrinterGear.
I've included a small 10mm test cube, which is what I use to initially test various settings before moving on to more complicated calibration prints.
I hope this proves to be useful.
| Robo3D_3DPG_PLA_0.3.fff | 10.7KB | |
| testcube_10mm.stl | 684.0B |
