I made this design so I could fit my AEM Wideband O2 controller into one of my "eye ball" air vent inlets in my 2002 MX-5 NBFL. It is compatible with all MX-5s from 1990 to 2004, as far as I know these models had the same vent holes. I printed it on my Creality LD-002H SLA printer, with 85% support from baseplate.
I don't think, that this would be too good with an FDM printer, but I didn't try it.
If you find this model useful and is a help for you, consider leaving a tip of a few bucks, I would be very grateful.
For hungarians:
// Ha magyar mazdás csopikban meglátom, hogy valaki árulni fogja ezt nyomtatásra, akkor részesedést kérek, mégis csak én modelleztem :D //
| AEM_WidebandHolder.ipt | 439.5KB | |
| AEM_WidebandHolder.stl | 324.3KB |
