For the Champion Dual Fuel Inverter Generator I found myself searching for some tools every time I would start it. These where a screwdriver for opening the side lid to check the oil level, a socket wrench to tighten or release the holder for the reduction valve and a tool to poke the membrane of the reduction valve to force propane to the generator.
This tool can do all three.
None of these screws need to be tightened very hard, so I make sure they are loose enough for this PLA tool to handle.
Added some holes on the side to allow a rope or a velcro cable tie to make sure it's always available at the generator.
Check out the notes under print settings for how I decided to print it.
| Champion_Generator_Tool.step | 72.0KB | |
| Champion_Generator_Tool.stl | 1.2MB |
