Used Tharevs excellent stl in two pieces and put them together to a single print. Also added a rfid-tag holder as my work has a yellow rfid-tag so it suited well. I have also modified the stl so it is easier to insert and remove the access-card (in card credit format).

And yes, thats me on the picture... what a stud!

I think I have adjusted it in about 10 different iterations and are quite happy with the result. Used Tinkercad and you do not want to use that.. Its a lot of grouping with different objects and are a mess.. But the end result is quite good... I was to lazy to use Fusion 360.

Printed in "marble pla" but I think it would be better to be printed in a dark grey stone pla if available.. Very practical to have the rfid-tag and identification card in the same holder.. The RFID-tag fits very well and are almost stuck, even so I have added a "stopper" so it cant be dropped.. There is also a possibility to use it in the other direction if you want to have the rfid-tag upwards if wearing a neck-band using the hole on the side wich I also changed from Tharevs design after watching and studying the multicard in the Fifth element where I observed that there was a small hole there.

I have painted the small square on the side white and the small line under it in red... Did not have any yellow paint but on the side there should also be some yellow paint.

Also possible to add resin to have that transparent globe over the circle.

The back is just a random backside picture that I found when I googled it, dont know about copyrights there so I dont include it as a file.