Multicopter Xiaomi Carrier 3D Printer Model
The file 'Multicopter Xiaomi Carrier 3D Printer Model' is (skp,stl) file type, size is 1.6MB.
The file 'Multicopter Xiaomi Carrier 3D Printer Model' is (skp,stl) file type, size is 1.6MB.
Experiment of a action cam carrier.Still testing configurations...
Modified design of the CoinQuadcopter FPV.
Frame superstable for FPV modified to carry a Xiaomi Yi camera only clipping on the bottom.
You will need:
-8 motors 8 class or 7. Like these ones
http://www.banggood.com/8_5x20mm-Motor-For-Walkera-W100s-V929-V949-V959-V969-p-75096.html?AID=12202217&PID=3836173&SID=ik3n9359a40004o402ecu&source=affiliate&utm_source=Banggood_CJ&utm_medium=commission_junction&utm_campaign=OpenPilot&utm_content=sandy
-8 propellers direct drive like these
http://www.banggood.com/Hubsan-H107-X4-RC-Quadcopter-Spare-Parts-Propeller-Blade-Set-p-72513.html?p=OY2106728901201408U4
-1S 300-500 Mah with high discharge rate so can give enough push to the eight motors 40c or higher
-for the control board you can use your prefered board. I used MicroMultiwii with dms2 receiver onboard from hobbyking.( there is only connection for four motors, but the mosfet are rated powerfull enough to connect two motors on each one)
| 3DPRINT-DroneV2XIAOMICarrier.skp | 2.8MB | |
| 3DPRINT-DroneXiaomiCarrier.stl | 59.7KB |
