Easy to print and assemble Stackable tower for curing multiple small prints at the same time.
Option one - Magnetized - ready for 5x1 or 5x2mm magnets - super sturdy assembly, but requires a little bit of Supports. Can be printed in 3 parts Bot + Mid + Disc, or only stack a few Bot parts one on top the the other + 1 Disc for the Top.
Option two - No magnets - also No supports needed. Tolerance is 0.4 between each level.
Both Bot parts come pre - punched.
But if you think you want even more light to go through - print in 3 parts (with Mid and Disk) and adjust the Discs to have 0 top and 0 bottom layers, this way you control the infill density only.
All the Bottoms and Disks have a small raised edge which is exactly 0.96mm - so two walls on a 0,4 nozzle.
This one is sized up for Anycubic Mercury Plus, but if someone needs - I can make different sizes on demand.
| Cure_tower_bot.stl |
| Cure_tower_bot_NoMag.stl |
| Cure_tower_Disc.stl |
| Cure_tower_Mid.stl |
| Cure_tower_Mid_NoMag.stl |
