MSI Ventus 2x 4070 Ti Super Deshroud Mod / 2 X 92mm Fan GPU Bracket 3D Printer Model
The file 'MSI Ventus 2x 4070 Ti Super Deshroud Mod / 2 X 92mm Fan GPU Bracket 3D Printer Model' is (stl) file type, size is 29.8KB.
The file 'MSI Ventus 2x 4070 Ti Super Deshroud Mod / 2 X 92mm Fan GPU Bracket 3D Printer Model' is (stl) file type, size is 29.8KB.
Remixed version of Hathek's original design to mount onto an MSI Ventus 2x 4070 Ti Super (unsure if this will fit other 2x cards from MSI). It uses the same 4 mounting locations as the stock shroud. Make sure to print in PETG/ABS and thread the mounting posts BEFORE you slot it into the GPU. The mounting posts are small, so just be careful when threading them - I used the stock screws to thread + screw the bracket in place. I used 2 x 92mm NF-A9s from Noctua but any 92mm fans should work.
Also: the fourth mounting post located near the very edge of the bracket prevents a fan screw from being installed next to it. I didn't screw a fan screw in this one (so the fan is held by three screws). You could probably also just use a ziptie here.
| Ventus2x4070TiS_GPU_Bracket_92mm.stl | 147.7KB |
