STANDOFF SPACING 25MM (Center to Center)
Remote ID mount for Project 399 Super G. Allows for a compact stack of the mrid module and the RUSHFPV GNSS MINI M10 GPS. This module gets a super fast lock due to the new M10. Also uses exclusively solder pads so you don't have to worry about plugs coming undone.
Remote ID module goes in first. And then a piece of VHB double sided tape and the gps atop that. There are 5 total slots where I have passed small zip ties through and put another one on the other side and trimmed them both down to keep the profile smaller. Not necessary I just don't fully true the surfaces that the vhb is applied to.
Have to make a small cable to connect the mrid to the gps but that should be self explanatory. Allows the plug going to the fc to route out the print and towards the front of the drone.
Antenna holes can be used with with either sma or you can throw the antenna through the hole and let it float in place. Might make one for the o3 at some point. But for now the dual antenna should suffice.
GPS USED - RUSHFPV GNSS MINI M10
https://www.aliexpress.us/item/3256805106998201.html?spm=a2g0o.order_list.order_list_main.26.6e161802jQzmAu&gatewayAdapt=glo2usa
https://rushfpv.net/products/rushfpv-gnss-mini
Remote ID used - Phoenix UAS mRID
https://www.phoenixuas.us/shop/p/spring-bowl-rltkk-jy5sr-fjw6l-dp8lg-fbmgj-cs6n2-zpp9a-glgfp
Zip tie hole dims
2.5mm wide x 1.1mm tall
| RID_RUSHFPV_GPS_Antenna_Mount_v2_ANGLED_WITH_IMMORTAL_T.3mf | 164.0KB | |
| RID_RUSHFPV_GPS_Antenna_Mount_v2_ANGLED_WITH_IMMORTAL_T.f3d | 462.6KB | |
| RID_RUSHFPV_GPS_Antenna_Mount_v2_ANGLED_WITH_IMMORTAL_T.stl | 159.8KB | |
| RID_RUSHFPV_GPS_v9_FLAT_ANTENNA.3mf | 154.0KB | |
| RID_RUSHFPV_GPS_v9_FLAT_ANTENNA.f3d | 361.1KB | |
| RID_RUSHFPV_GPS_v9_FLAT_ANTENNA.stl | 126.7KB |
