THE BOX, THE BOX!!
A very simple box to print and build.
There is no secret locks or mazes to open the box, just open the cover... BUT there is a false bottom, to open it there is a small hole on the other side, where you can put a paperclipe (for example)but is not so easy, first you have to turn the dot of the question mark, and then push... Well for a clear explanation just watch this video:
The false bottom fits perfectly into the box, but if is not your case sand the corners a little.
To mount the lock, put the lock first into the hole, and then stick it with the question dot with superglue or similar. Be careful to don´t stick the question dot to the box.
Stick the question marks in the box in the sizes you want
To save some PLA (and time) when you print the box you can use this settings:
I hope you like it :)
Check out my other puzzle boxes
Cthulhu puzzle box https://www.thingiverse.com/thing:3440319
The necronomicon maze box https://www.thingiverse.com/thing:3509643
Mr. Burns Mystery Box https://www.thingiverse.com/thing:3845118
Steampunk Maze Box https://www.thingiverse.com/thing:3984338
Another puzzle box https://www.thingiverse.com/thing:4217748
| box.stl | 432.3KB | |
| cover.stl | 596.8KB | |
| false_bottom.stl | 86.3KB | |
| lock.stl | 89.9KB | |
| question_lock.stl | 40.7KB | |
| question_mark.stl | 28.0KB | |
| question_pack.stl | 140.3KB |
