Parts made for MPSM bed rewire (no-drill method). Everything you need to finish it off can be found here:
Print a few of the BracketClips to have extra in case they snap. They're just push in clips to hold the BracketMount to the back of the print bed.
Use cable chain found here (I'd suggest 9 pairs, printed with 10% zig-zag support):
https://www.thingiverse.com/thing:1036698
Snap the cable chain together and attach one end to the BracketMount. Feed the wires from the bed through this all.
Print and attach the SidePanelConnector to the end, feed the wires through. The SidePanelConnector piece slides right into the port on the back half of the side panel. Then screw the panel back on.
Use side panel found here:
Front half: https://www.thingiverse.com/thing:2370329
Back half: https://www.thingiverse.com/thing:2451362
Everything snaps together and finishes off the rewire from bed to base.
| BracketClip04.stl | 48.9MB | |
| BracketMount.stl | 863.2KB | |
| SidePanelConnector.stl | 25.6MB |
