MouseTrap 3D Printer Model
The file 'MouseTrap 3D Printer Model' is (stl) file type, size is 189.1KB.
The file 'MouseTrap 3D Printer Model' is (stl) file type, size is 189.1KB.
The 'MouseTrap' is a small but simple device that keeps your wired computer mouse cable neatly coiled at the preferred length for use and/or when being transported.
The design fits common wired Mouse cables (3.25mm) so is a fine/detailed device to print. As some cables may vary slightly, and not all printers print the same, If you print a 'MouseTrap' and find it is either too tight or too loose on your Mouse Cable (it should be a snug press fit into the clips) uniformly scale it up or down slightly until you get a snug fitting result.
This is a small and easy print. On a Replicator 2 /5th Generation Replicator they print in less than 15 minutes including Raft. Using Raft is recommended as it is a small print. The design allows for it to be printed without support (PLA). Please refer to print settings for additional details.
Note: If you like this check out all my other practical and fun designs.... and post images of them in use!
| mousetrap.stl | 474.4KB |
