Mounting Fixture For 1/2″ Pipe Fitting Wall Elbow 3D Printer Model
The file 'Mounting Fixture For 1/2″ Pipe Fitting Wall Elbow 3D Printer Model' is (stl) file type, size is 2.1MB.
The file 'Mounting Fixture For 1/2″ Pipe Fitting Wall Elbow 3D Printer Model' is (stl) file type, size is 2.1MB.
1/2 inch threaded elbow mounting fixtures.
The elbow is placed 5mm below the surface level.
Attention! If you use heat to join pipes (soldering, welding), always remove this holder!
Use this installation procedure: (according to photos)
1 - place fixtures with elbows to their positions
2 - remove the elbows and solder the nearby joints outside the fixtures
3 - screw the elbows back on and finish the rest of the pipes
4 - use a cast to fix the elbows
5 - disassemble the fixture - the elbows are held in place with a cast
6 - now you can finish soldering
| base_DUAL.stl | 147.2KB | |
| base_MONO.stl | 110.8KB | |
| hand_element.stl | 100.7KB | |
| shaft_with_thread.stl | 4.0MB |
