Water Falls in the mountains - I designed this over time, to have a nice portable water fall that was pleasing to look at. Its all self contained. The pump can be inside or use with another mini pump with a tube externally if you would like. This is also a single print with minimal support designed for ease of use. If the pump pressure is set right, it is designed to have three separate falls, The upper, overflow from secondary above the trees then to the right into the pond.

I used grey PLA from Inland, and it worked great. So with a $1.30 pump off ebay and a piece of tube, with the cost of PLA it was under $5.

enjoy

Sherm

Update, the STL file that has always been uploaded is version 17b, but the photos were from 16b. I've uploaded photos of print from 17b. As you can see I made the tree trunks thicker. I only had 2 break loose when removing support, but ca glue puts them right back on in seconds.
UPDATE 6-3-18 I've removed version 17b and replaced with version 19 which has improved water path and .5cm connector for tubing now.

Other designs:

https://www.thingiverse.com/thing:2877757 - Garden solar light housing
https://www.thingiverse.com/thing:2878937 - CR-10/CR10 mini spool extender
https://www.thingiverse.com/thing:2892093 - Custom Design Desk Lamp
https://www.thingiverse.com/thing:2876013 - Cat Play Toy
https://www.thingiverse.com/thing:2876129 - fireflys

New:
https://www.thingiverse.com/thing:2895807 - Vase
https://www.thingiverse.com/thing:2896380 - Non locking Stone box
https://www.thingiverse.com/thing:2896425 - Cat Play Toy 2
https://www.thingiverse.com/thing:2896468 - Anemometer wind gauge
https://www.thingiverse.com/thing:2896539 - Solar Light House
https://www.thingiverse.com/thing:2896579 - Hide a key flag holder
https://www.thingiverse.com/thing:2896598 - Invisible Hook

resub