Mount Brick is a system designed to bring your LEGO® collection into view as wall art around your home.

Description: This collection contains designs compatible with LEGO Technic® beams. I have grouped the Mount Brick design by function. Please see my designs page for other LEGO® compatible wall mount options.

Installation: To install you will need: 2 Hillman™ Wall Dog™ drywall screws, level, pencil, drill, a small drill bit, and a phillips head screwdriver. See image 6 for a visual on the installation process. All measurements were designed using the length of LEGO® bricks. The mounting holes are 6 studs apart. See images 4 and 5 for additional measurements. Ensure your measurement brick is vertical by using a level before marking its position. Drill a pilot hole for your screws where the corner of the brick sat on the wall. this will be very slightly to the inside of where your pencil marks are located. The screws can then be aligned with the pilot holes to finish installation.

Notes:
-Print these parts as presented to prevent sheer stress from delaminating the piece.
-Use a template to easily align multiple wall mounts. Build one that matches the alignment on the set you intend to display.
-There is a small amount of wiggle room if your drywall screw mount doesn't align quite right. Loosen the screws a quarter turn and shift it into position before tightening them back down.
-3D printed parts do not match the precision of LEGO® part. These parts are designed with tolerances for FDM printers. SLA prints have shown issues with brittleness when printing these designs.
-The lower hole in the horizontal mount is designed to match the angle of a Technic® bent liftarm as shown in image 3.

Disclaimer: I am not associated with any of the following legal entities.They are mentioned only as their products are compatible with this design. LEGO®, LEGO Technic®, Hillman™ Wall Dog™, Command™ Strips, Star Wars™. There is no intention to infringe on any of their intellectual property.